Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-11
Description
Use the ntdp enable command to enable NTDP globally or on a port.
Use the undo ntdp enable command to disable NTDP globally or on a port.
By default, NTDP is enabled globally and on ports.
Note that the NDTP cannot operate if it is enabled on a port where NDP is disabled.
Example
# Enable NTDP globally on the switch.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ntdp enable
1.2.4 ntdp explore
Syntax
ntdp explore
View
User view
Parameter
None
Description
Use the ntdp explore command to start topology information collection manually.
Normally, NTDP collects network topology information periodically. You can also start
topology information collection manually whenever needed by executing this command.
When you execute this command, NTDP collects the NDP information of every device
and the information about the connections between the local switch and all of its
neighbor switches in the specified network scope. The information is useful for the
management device or network management system to acquire the network topology
and to manage and monitor the devices.
Example
# Start the topology collection.
<Quidway> ntdp explore
To Next Page
Loading...
Need help?
General