Huawei Quidway S3900 Series Command Manual

Command Manual – NTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 NTP Configuration Commands
Huawei Technologies Proprietary
1-8
View
VLAN interface view
Parameter
authentication-keyid key-id: Specifies the key ID used when sending messages to the
broadcast clients. The key-id argument ranges from 1 to 4294967295. This parameter
is not needed if you specify not to perform authentication.
version number: Specifies the NTP version number which ranges from 1 to 3. The
default version number is 3.
Description
Use the ntp-service broadcast-server command to configure an Ethernet switch to
operate in the NTP broadcast server mode and send NTP broadcast packets through
the current interface.
Use the undo ntp-service broadcast-server command to cancel the configuration.
By default, no Ethernet switch operates in the NTP broadcast server mode.
Example
# Configure to send NTP broadcast packets through VLAN interface 1, using the key
numbered 4 for encryption and setting the NTP version number to 3.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ntp-service broadcast-server authentication-key 4
version 3
1.1.9 ntp-service in-interface disable
Syntax
ntp-service in-interface disable
undo ntp-service in-interface disable
View
VLAN interface view
Parameter
None
Description
Use the ntp-service in-interface disable command to disable the interface from
receiving NTP packets.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English