Huawei Quidway S3900 Series - Sftp Source-Ip

Command Manual –SSH Terminal Service
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 SSH Terminal Service
Configuration Commands
Huawei Technologies Proprietary
1-42
Example
# Specify source interface Vlan-interface 2 for SFTP Client.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] sftp source-interface Vlan-interface 2
1.4.20 sftp source-ip
Syntax
sftp source-ip ip-address
undo sftp source-ip
View
System view
Parameter
ip-address: Source IP address needed to set.
Description
Use the sftp source-ip command to specify the source IP address for SFTP Client.
When the specified ip-address is not the IP address of the device, the command
prompts configuration fails.
Use the undo sftp source-ip command to remove the specified source IP address.
Then, the address of the device determined by the system is for the user to access to
the SFTP Server.
Example
# Specify source IP address 192.168.0.1 for SFTP Client.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] sftp source-ip 192.168.0.1