Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 6 PIM Configuration Commands
Huawei Technologies Proprietary
6-14
Description
Use the pim neighbor-policy command to configure the router to filter the PIM
neighbors on the current VLAN interface.
Use the undo pim neighbor-policy command to disable the filtering.
Only the routers that match the filtering rule in the ACL can serve as a PIM neighbor of
the current VLAN interface.
The new configuration overwrites the old one if you run the command for a second time.
Example
# Configure that 10.10.1.2 can serve as a PIM neighbor of the Vlan-interface10, but not
10.10.1.1.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] multicast routing-enable
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] pim neighbor-policy 2000
[Quidway-Vlan-interface10] quit
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.10.1.2 0
[Quidway-acl-basic-2000] rule deny source 10.10.1.1 0
6.1.15 pim sm
Syntax
pim sm
undo pim sm
View
VLAN interface view
Parameter
None
Description
Use the pim sm command to enable the PIM-SM protocol.
Use the undo pim sm command to disable the PIM-SM protocol.
By default, the switch disables the PIM-SM protocol.
You must enable the PIM-SM protocol on each VLAN interface respectively. Generally,
the PIM-SM protocol is enabled on each VLAN interface.
To Next Page
Loading...
Need help?
General