Command Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Login Commands
Huawei Technologies Proprietary
1-26
Description
Use the telnet source-ip command to specify the source IP address for a Telnet client.
If the IP address specified is not an IP address of the device, your configuration fails.
Use the undo telnet source-ip command to clear the source IP address configuration.
After that, you can access the Telnet server from Telnet client using the IP address
determined by the system.
Example
# Specify the source IP address to be 192.168.1.1 for the Telnet client.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] telnet source-ip 192.168.1.1
1.1.29 user-interface
Syntax
user-interface [ type ] first-number [ last-number ]
View
System view
Parameter
type: User interface type.
first-number: User interface index, which identifies the first user interface to be
configured.
last-number: User interface index, which identifies the last user interface to be
configured.
Description
Use the user-interface command to enter one or more user interface views to perform
configuration.
Example
# Enter VTY 0 user interface view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] user-interface vty 0
[Quidway-ui-vty0]
To Next Page
Loading...
Need help?
General