Huawei Quidway S3900 Series - Ntp-Service Max-Dynamic-Sessions; Ntp-Service Multicast-Client

Command Manual – NTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 NTP Configuration Commands
Huawei Technologies Proprietary
1-9
Use the undo ntp-service in-interface disable command to enable the interface to
receive NTP packets.
By default, the interface can receive NTP packets.
Example
# Disable VLAN interface 1 from receiving NTP packets.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ntp-service in-interface disable
1.1.10 ntp-service max-dynamic-sessions
Syntax
ntp-service max-dynamic-sessions number
undo ntp-service max-dynamic-sessions
View
System view
Parameter
number: Maximum number of the NTP sessions that can to be established locally. This
argument ranges from 0 to 100.
Description
Use the ntp-service max-dynamic-sessions command to set the maximum number
of NTP sessions that can be established locally.
Use the undo ntp-service max-dynamic-sessions command to restore the default.
By default, up to 100 NTP sessions can be established locally.
Example
# Configure the maximum number of dynamic NTP sessions that can be established
locally to be 50.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ntp-service max-dynamic-sessions 50
1.1.11 ntp-service multicast-client
Syntax
ntp-service multicast-client [ ip-address ]