Command Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-10
View
System view, Ethernet port view
Parameter
user-number: Maximum number of users a port can accommodate, ranging from 1 to
256. The default number is 256.
interface-list = { interface-name [ to interface- name] & < 1-10 >. The interface-name
argument is the port index of an Ethernet port and can be specified in this form:
interface-name = { interface-type interface-num }, in which, interface-type specifies the
type of a port and interface-num identifies the port number. Note that the interface
name after the keyword to must have an interface-num that is greater than or equal to
that of the interface-name before the to keyword. &<1-10> means that up to 10 port
indexes/port index lists can be provided,
Description
Use the dot1x max-user command to set the maximum number of supplicant systems
an Ethernet port can accommodate.
Use the undo dot1x max-user command to revert to the default maximum supplicant
system number.
When being executed in system view, these two commands apply to all Ethernet ports
of the switch if you do not provide the interface-list argument. And if you specify the
interface-list argument, these commands apply to the specified Ethernet ports.
When being executed in Ethernet port view, these two commands apply to the current
Ethernet port only. In this case, the interface-list argument is not needed.
Related command: display dot1x.
Example
# Configure the maximum number of users that Ethernet1/01 can accommodate to be
32.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] dot1x max-user 32 interface Ethernet 1/0/1
1.1.7 dot1x port-control
Syntax
dot1x port-control { auto | authorized-force | unauthorized-force } [ interface
interface-list ]
undo dot1x port-control [ interface interface-list ]
To Next Page
Loading...
Need help?
General