Huawei Quidway S3900 Series Command Manual

Command Manual - HWPing
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 HWPing Commands
Huawei Technologies Proprietary
1-1
Chapter 1 HWPing Commands
1.1 HWPing Commands
1.1.1 count
Syntax
count times
undo count
View
HWPing test group view
Parameter
times: Number of the test packets to be transmitted. It is in the range 1 to 15 and
defaults to 1.
Description
Use the count command to configure the number of packets to be sent for each test.
Use the undo count command to restore the default.
A test timer is started when the system sends the first test packet. In the event that the
times argument is set greater than one, the system continues to send the second one
upon receipt of the reply to the first one. If receiving no reply upon expiry of the timer,
the system sends the second and all the remaining packets likewise.
Related command: frequency.
Example
# Set that the “administrator-icmp” test group sends ten packets for each test.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] hwping administrator icmp
[Quidway-hwping-administrator-icmp] count 10
1.1.2 destination-ip
Syntax
destination-ip ip-address
undo destination-ip

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English