Command Manual - CLI
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 CLI Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 CLI Configuration Commands
1.1 CLI Configuration Commands
1.1.1 command-privilege level
Syntax
command-privilege level level view view command
undo command-privilege view view command
View
System view
Parameter
level: Command Level. This argument ranges from 0 to 3.
view: Command view. This argument can be any command view the switch supports.
command: Command to be specified.
Description
Use the command-privilege level command to set the level of the specified
command in a specified view.
Use the undo command-privilege view command to restore the level of the specified
command in the specified view to the default.
Commands fall into four command levels: visit, monitor, system, and manage, which
are identified as 0, 1, 2, and 3 respectively. The administrator can change the level of a
command to enable users of specific level to utilize the command.
By default, the ping, tracert, and telnet commands are at the visit level (level 0); the
display and debugging commands are at the monitor level (level 1); all configuration
commands are at the system level (level 2); and FTP/TFTP/XModem and file system
related commands are at the manage level (level 3).
Example
# Specify the interface command in system view to be of level 0.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] command-privilege level 0 view system interface
To Next Page
Loading...
