Command Manual – System Maintenance and Debugging
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 Device Management Commands
Huawei Technologies Proprietary
3-9
After you execute the schedule reboot at command with a future date specified, the
switch will reboot at the specified time with at most one minute delay.
After you execute the schedule reboot at command without specifying a date, the
switch will:
z Reboot at the specified time on the current day if the specified time is later than the
current time.
z Reboot at the specified time on the next day if the specified time is earlier than the
current time.
After you execute the command, the system will prompt you to confirm. Enter "Y" or "y"
for your setting to take effect, and your setting will overwrite the old one (if available).
If you adjust the system time by the clock command after executing the schedule
reboot at command, the schedule reboot at command will be invalid and the
scheduled reboot will not happen.
Related command: reboot, display schedule reboot.
Example
# Suppose the current time is 05:06, schedule a reboot so that the switch reboots at
22:00 on the current day.
<Quidway> schedule reboot at 22:00
Reboot system at 22:00 2000/04/02(in 16 hours and 53 minutes)
confirm?[Y/N]:y
<Quidway>
3.1.12 schedule reboot delay
Syntax
schedule reboot delay { hh:mm | mm }
undo schedule reboot
View
User view
Parameter
hh:mm: Reboot waiting delay, where hh ranges from 0 to 720, and mm ranges from 0 to
59.
mm: Reboot waiting delay, ranging from 0 to 43,200 minutes.
Description
Use the schedule reboot delay command to schedule a reboot on the switch, and set
the reboot waiting delay.
To Next Page
Loading...
Need help?
General