Huawei Quidway S3900 Series - Igmp-Snooping Query-Interval

Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 IGMP Snooping Configuration
Commands
Huawei Technologies Proprietary
1-11
Parameter
None
Description
Use the igmp-snooping querier command to enable the IGMP Snooping querier
feature on the current VLAN of the Layer 2 multicast switch.
Use the undo igmp-snooping querier command to disable the IGMP Snooping
querier feature on the current VLAN of the Layer 2 multicast switch.
By default, the IGMP Snooping querier feature of the Layer 2 multicast switch is
disabled.
Example
# Enable the IGMP Snooping feature on VLAN 3 of the Layer 2 multicast switch.
<Quidway> system-view
System view, return to user view with Ctrl+Z.
[Quidway] igmp-snooping enable
[Quidway] vlan 3
[Quidway-vlan3] igmp-snooping enable
[Quidway-vlan3] igmp-snooping querier
1.1.12 igmp-snooping query-interval
Syntax
igmp-snooping query-interval seconds
undo igmp-snooping query-interval
View
VLAN view
Parameter
seconds: Interval for the Layer 2 multicast to send general query packets.
Description
Use the igmp-snooping query-interval command to configure the interval for the
Layer 2 multicast switch to send general query packets.
Use the undo igmp-snooping query-interval command to restore the interval to the
default value.
These commands are effective after the IGMP Snooping querier feature is enabled.
Otherwise, the switch will not send general query packets. The configured query
interval must be longer than the maximum response interval of the host,