Huawei Quidway S3900 Series - Chapter 2 DHCP;BOOTP Client Configuration; DHCP Client Configuration Commands; Debugging Dhcp Client

Command Manual - Management VLAN
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 2 DHCP/BOOTP Client
Configuration
Huawei Technologies Proprietary
2-1
Chapter 2 DHCP/BOOTP Client Configuration
2.1 DHCP Client Configuration Commands
2.1.1 debugging dhcp client
Syntax
debugging dhcp client { all | error | event | packet }
undo debugging dhcp client { all | error | event | packet }
View
User view
Parameter
all: Enables all types of debugging for dynamic host configuration protocol (DHCP) or
bootstrap protocol (BOOTP) client.
error: Enables debugging for DHCP/BOOTP client error messages (including the
information about unidentified packets).
event: Enables debugging for DHCP/BOOTP client events (including address
allocation and data update).
packet: Enables debugging for packets received/transmitted by a DHCP/BOOTP
client.
Description
Use the debugging dhcp client command to enable debugging for the DHCP/BOOTP
client.
Use the undo debugging dhcp client command to disable debugging output.
By default, debugging for DHCP/BOOTP client is disabled.
Disable debugging as soon as debugging is over, because debugging occupies plenty
of system resources.
Example
# Enable debugging for DHCP/BOOTP client events.
<Quidway> debugging dhcp client event