Command Manual – IRF Fabric
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 IRF Fabric Commands
Huawei Technologies Proprietary
1-9
 Note:
z Establishing an IRF system requires a high consistency of the configuration of each
device. Hence, before you enable the fabric port, do not perform any configuration
for the port, and do not enable some functions that affect the IRF (such as
TACACAS and VLAN-VPN) for other ports or globally. Otherwise, you cannot
enable the fabric port. Refer to the error information output by devices for the detail
restricts.
z When you have enable fabric port function for a fabric port group, if you need to
change the fabric port group, you must disable the fabric function of the current
fabric port group before you execute the enable command on another group.
Otherwise, the system will prompt that the current fabric port group is in use, you
cannot change the fabric port group.
Example
# Set GigabitEthernet1/1/3 port as a fabric port.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] fabric-port GigabitEthernet1/1/3 enable
1.1.9 ftm fabric-vlan
Syntax
ftm fabric-vlan vlan-id
undo ftm fabric-vlan
View
System view
Parameter
vlan-id: ID of the IRF fabric VLAN, in the range of 2 to 4094 By default, the number of
the IRF Fabric VLAN is 4093.
Description
Use the ftm fabric-vlan command to specify the VLAN that the switch uses for IRF
fabric.
Use the undo ftm fabric-vlan command to restore the default VLAN.
You need to specify the IRF fabric VLAN before the IRF fabric is established. Moreover,
the VLAN you specified must be the one that has not been created.
To Next Page
Loading...
Need help?
General