Command Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
Huawei Technologies Proprietary
1-74
port: Port number of the server, which is in the range of 1 to 65535 and defaults to 49.
Description
Use the secondary authentication command to configure a secondary HWTACACS
authentication server.
Use the undo secondary authentication command to delete the configured
secondary authentication server.
Note that:
z You are not allowed to assign the same IP address to both primary and
secondary authentication servers; otherwise, unsuccessful operation is
prompted.
z If you repeatedly use this command, the latest configuration overwrites the
previous one.
z You can remove an authentication server only when it is not being used by any
active TCP connections.
Related command: display hwtacacs.
Example
# Configure a secondary authentication server.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] hwtacacs scheme hwt1
[Quidway-hwtacacs-hwt1] secondary authentication 10.163.155.13 49
1.3.16 secondary authorization
Syntax
secondary authorization ip-address [ port ]
undo secondary authorization
View
HWTACACS scheme view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
By default, the IP address of the secondary authorization server is 0.0.0.0.
port: Port number of the server, in the range of 1 to 65535. By default, it is 49.
To Next Page
Loading...
Need help?
General