Command Manual – Information Center
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Information Center Configuration
Commands
Huawei Technologies Proprietary
1-10
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in
turn) console, monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6,
channel7, channel8, channel9.
facility: Configures the recording process of the log host.
local-number: Recording tool of the log host, ranging from local0 to local7.
language: Configures the log recording language.
chinese, english: Switches the log recording language between Chinese and English.
Description
Use the info-center loghost command to enable information output to a log host
through setting the IP address of the log host.
Use the undo info-center loghost command to disable the information output.
By default, the switch does not output information to the log host.
This command works only when the information center is enabled for the system.
 Note:
Be sure to set the correct IP address in the info-center loghost command. A loopback
IP address will cause an error message, prompting invalid address.
Related command: info-center enable and display info-center.
Example
# Configure the Ethernet switch to send information to the Unix workstation whose IP
address is 202.38.160.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] info-center loghost 202.38.160.1
1.1.11 info-center loghost source
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
To Next Page
Loading...
Need help?
General