Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 6 PIM Configuration Commands
Huawei Technologies Proprietary
6-20
If resource address filtering is configured, as well as advanced ACLs, then the router
filters the resource and group addresses of all multicast data packets received. Those
not matched will be discarded.
When this feature is configured, the router filters not only multicast data, but the
multicast data encapsulated in the registration packets.
The new configuration overwrites the old one if you run the command for a second time.
Example
# Set to receive the multicast data packets from source address 10.10.1.2, but discard
those from 10.10.1.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] multicast routing-enable
[Quidway] pim
[Quidway-pim] source-policy 2000
[Quidway-pim] quit
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.10.1.2 0
[Quidway-acl-basic-2000] rule deny source 10.10.1.1 0
6.1.22 static-rp
Syntax
static-rp rp-address [ acl-number ]
undo static-rp
View
PIM view
Parameter
rp-address: Static RP address, only being legal unicast IP address.
acl-number: Basic ACL, used to control the range of multicast group served by static RP,
which ranges from 2000 to 2999. If an ACL is not specified upon configuration, static
RP will serve all multicast groups; if an ACL is specified, static RP will only serve the
multicast group passing the ACL.
Description
Use the static-rp command to configure static RP.
Use the undo static-rp command to remove the configuration.
To Next Page
Loading...
Need help?
General