Command Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-17
By default, an 802.1x supplicant system enables the use of multiple network cards,
proxies, or IE proxies. If CAMS has these features disabled, it would notify the 802.1
supplicant system to have the corresponding features disabled as well after the latter
has successfully passed the authentication.
 Note:
z The supplicant system proxy checking function needs the support of Huawei's
802.1x client program.
z The supplicant system proxy checking function takes effect only after it has been
enabled on CAMS and the client version checking function is enabled on the switch
(using the dot1x version-check command).
Related command: display dot1x.
Example
# Configure to disconnect any supplicant system connected to Ethernet1/0/1 through
Ethernet1/0/8 ports if it has been detected logging in through a proxy.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] dot1x supp-proxy-check logoff
[Quidway] dot1x supp-proxy-check logoff interface Ethernet 1/0/1 to Ethernet
1/0/8
# Configure the switch to send Trap packets if a supplicant system connected to
Ethernet1/0/9 port is detected logging in through a proxy.
[Quidway] dot1x supp-proxy-check trap
[Quidway] dot1x supp-proxy-check trap interface Ethernet 1/0/9
Or
[Quidway] dot1x supp-proxy-check trap
[Quidway] interface Ethernet 1/0/9
[Quidway-Ethernet1/0/9] dot1x supp-proxy-check trap
1.1.13 dot1x timer
Syntax
dot1x timer { handshake-period handshake-period-value | quiet-period
quiet-period-value | tx-period tx-period-value | supp-timeout supp-timeout-value |
server-timeout server-timeout-value | ver-period ver-period-value }
To Next Page
Loading...
Need help?
General