Command Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
Huawei Technologies Proprietary
1-75
Description
Use the secondary authorization command to configure a secondary HWTACACS
authorization server.
Use the .undo secondary authorization command to delete the configured
secondary authorization server.
Note that:
z You are not allowed to assign the same IP address to both primary and
secondary authorization servers.
z If you repeatedly use this command, the latest configuration overwrites the
previous one.
z You can remove an authorization server only when it is not being used by any
active TCP connections.
Related command: display hwtacacs.
Example
# Configure the secondary authorization server.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] hwtacacs scheme hwt1
[Quidway-hwtacacs-hwt1] secondary authorization 10.163.155.13 49
1.3.17 timer quiet
Syntax
timer quiet minutes
undo timer quiet
View
HWTACACS scheme view
Parameter
minutes: Length of the timer in minutes, in the range of 1 to 255. By default, the
primary server must wait five minutes before it resumes the active state.
Description
Use the timer quiet command to set the duration that a primary server must wait
before it can resume the active state.
Use the undo timer quiet command to restore the default (five minutes).
Related command: display hwtacac.
To Next Page
Loading...
Need help?
General