Huawei Quidway S3900 Series Command Manual

Command Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-4
Field Description
ENABLE PoE enabled/disabled status on the port
MODE
PoE mode on the port:
z signal: PoE through the signal cable
z spare: PoE through the spare cable
PRIORITY
PoE priority of the port:
z critical: Highest
z high: High
z low: Low
STATUS
PoE status on the port:
z user command set port to off: PoE to the port is
turned off by the user
z Standard PD was detected: A standard PD is
detected
z PD detection is in process: PDs are being
detected
1.1.2 display poe interface power
Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Parameter
interface-type interface-number: Port on the switch. Refer to Command Manual – Port
for details.
Description
Use the display poe interface power command to view the power information of a
specific port of the switch. If the interface-type interface-number argument is not
specified, the command displays the power information of all ports of the switch.
Example
# Display the power information of Ethernet 1/0/10.
<Quidway> display poe interface power Ethernet1/0/10
Port power :12400 mW
# Display the power information of all ports.
<Quidway> display poe interface power
PORT INDEX POWER (mW) PORT INDEX POWER (mW)

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English