Command Manual – NTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 NTP Configuration Commands
Huawei Technologies Proprietary
1-13
1.1.15 ntp-service unicast-peer
Syntax
ntp-service unicast-peer { remote-ip | peer-name } [ authentication-keyid key-id |
priority | source-interface Vlan-interface vlan-id | version number ]*
undo ntp-service unicast-peer { remote-ip | peer-name }
View
System view
Parameter
remote-ip: IP address of the NTP peer. This argument cannot be a broadcast address,
a multicast address or the IP address of a reference clock.
peer-name: Peer host name, a string comprising 1 to 20 characters.
authentication-keyid key-id: Specifies the key ID used when sending messages to the
peer. The key-id argument ranges from 1 to 4294967295. By default, the authentication
is not enabled.
Priority: Specifies the peer identified by the remote-ip argument to be the preferred
peer for synchronization.
source-interface Vlan-interface vlan-id: Specifies an interface whose IP address is to
be used as the IP addresses of the NTP packets sent to the peer.
vlan-id: VLAN interface number.
version number: Specifies the NTP version number. The number ranges from 1 to 3
and defaults to 3.
Description
Use the ntp-service unicast-peer command to configure an Ethernet switch to be an
active NTP peer.
Use the undo ntp-service unicast-peer command to cancel the configuration.
By default, an Ethernet switch is not an active NTP peer.
 Note:
If you specify a remote server to be the peer of the local Ethernet switch by providing
the remote-ip argument in the ntp-service unicast-peer command, the local switch
operates in the active peer mode. In this case, the local switch and the remote server
can be synchronized to each other.
To Next Page
Loading...
Need help?
General