Huawei Quidway S3900 Series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-4
View
Any view
Parameter
View
Description
Use the display rip interface command to display RIP interface information.
Example
# Display RIP interface information.
<Quidway> display rip interface
RIP Interface: public net
Address Interface Ver MetrIn/Out Input Output Split-horizon
1.0.0.1 Vlan-interface100 2 0/1 on on on
Table 2-2 Description on the fields of the display rip interface command
Field Description
Address
IP address of the interface running RIP (You need to
use the network command to enable the network
segment on which the address resides.)
Interface
Name of the interface running RIP. The IP address of
the interface corresponds to that in the Address field.
Ver Version of RIP running on the interface
MetrIn/Out
Additional routing metric added when a route is
received/sent
Input
Indicates whether to allow the interface to receive RIP
packets ("on" means yes; "off" means no).
Output
Indicates whether to allow the interface to send RIP
packets ("on" means yes; "off" means no).
Split-horizon
Indicates whether split horizon is enabled ("on" means
yes; "off" means no)
2.1.5 display rip routing
Syntax
display rip routing

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English