Huawei Quidway S3900 Series - Display Multicast Routing-Table

Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 2 Common IP Multicast Configuration
Commands
Huawei Technologies Proprietary
2-2
Total 1 entry Listed
The following table describes the fields in the displayed information above:
Table 2-1 Description on the fields of the display multicast forwarding-table command
Field Description
Multicast Forwarding Cache Table Multicast forwarding table
Total 1 entries Total number of entries
00001 Serial number of an entry
(10.0.0.4, 225.1.1.1) (s,g)
iif Vlan-interface2, 0 oifs
The incoming interface of the multicast
forwarding table is vlan-interface 2, and the
multicast forwarding table does not have an
outgoing interface.
Matched 122 pkts(183000 bytes),
Wrong If 0 pkts
Forwarded 122 pkts(183000
bytes)
122 packets which are 183,000 bytes in all
match with the (s,g) entry, and 0 wrong
packet matches with the (s,g) entry.
122 packets which are 183,000 bytes in all
are forwarded.
2.1.2 display multicast routing-table
Syntax
display multicast routing-table [ group-address [ mask { mask | mask-length } ] |
source-address [ mask { mask | mask-length } ] | incoming-interface { interface-type
interface-number | register } ]*
View
Any view
Parameter
group-address: Multicast group address to specify a multicast group and display the
routing table information corresponding to this group, in the range of 224.0.0.0 to
239.255.255.255.
source-address: Unicast IP address of the multicast source.
incoming-interface: Specifies the incoming interface of the multicast routing entry.
register: Registration interface of PIM-SM.