Huawei Quidway S3900 Series - Pim

Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 6 PIM Configuration Commands
Huawei Technologies Proprietary
6-10
Description
Use the display pim rp-info command to view the RP information of the multicast
group.
In addition, this command can also display the BSR and static RP information.
Example
# View the RP information of the multicast group
<Quidway> display pim rp-info
PIM-SM RP-SET information:
BSR is: 4.4.4.6
Group/MaskLen: 224.0.0.0/4
RP 4.4.4.6
Version: 2
Priority: 0
Uptime: 00:39:50
Expires: 00:01:40
Table 6-5 Description on the fields of the display pim rp-info command
Field Description
PIM-SM RP-SET information: Combination of RP information
BSR is: 4.4.4.6
BSR is the VLAN interface of 4.4.4.6 in the
network
Group/MaskLen: 224.0.0.0/4
RP 4.4.4.6
Version: 2
Priority: 0
Uptime: 00:39:50
Expires: 00:01:40
The RP whose group address is 224.0.0.0 and
mask length is 4 is the virtual interface of the IP
address 4.4.4.6.
The priority of the version 2 RP is 0. It is up for 39
minutes and 50 seconds and expires in one
minutes and forty seconds
6.1.10 pim
Syntax
pim
undo pim
View
System view