Huawei Quidway S3900 Series - Display Ospf Error

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-17
Field Description
rtr, net, sumasb,
sumnet
Number of all LSAs in this area
Intra Area Number of intra-area routes
Inter Area Number of inter-area routes
Routing Table
ASE Number of external routes
3.1.17 display ospf error
Syntax
display ospf [ process-id ] error
View
Any view
Parameter
process-id: OSPF Process ID. If you do not specify a process ID, this command applies
to all current OSPF processes.
Description
Use the display ospf error command to display OSPF error information.
Example
# Display the OSPF error information.
<Quidway> display ospf error
OSPF Process 1 with Router ID 1.1.1.1
OSPF packet error statistics:
OSPF packet error statistics:
0: IP: received my own packet 0: OSPF: wrong packet type
0: OSPF: wrong version 0: OSPF: wrong checksum
0: OSPF: wrong area id 0: OSPF: area mismatch
0: OSPF: wrong virtual link 0: OSPF: wrong authentication type
0: OSPF: wrong authentication key 0: OSPF: too small packet
0: OSPF: packet size > ip length 0: OSPF: transmit error
0: OSPF: interface down 0: OSPF: unknown neighbor
0: HELLO: netmask mismatch 0: HELLO: hello timer mismatch
0: HELLO: dead timer mismatch 0: HELLO: extern option mismatch
0: HELLO: router id confusion 0: HELLO: virtual neighbor unknown
0: HELLO: NBMA neighbor unknown 0: DD: neighbor state low
0: DD: router id confusion 0: DD: extern option mismatch