Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-37
devices, you can control them remotely on the management device. For example, you
can reboot a member device that operates improperly and specify to delete the booting
configuration file when the member device reboots, and thus restore normal
communication between the management and member devices.
The eraseflash keyword specifies to delete the booting configuration file when the
member device reboots.
Example
# Reboot the member device numbered 2.
<aaa_0.Quidway> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Quidway] cluster
[aaa_0.Quidway-cluster] reboot member 2
1.3.22 snmp-host
Syntax
snmp-host ip-address
undo snmp-host
View
Cluster view
Parameter
ip-address: IP address of a SNMP host to be configured for a cluster.
Description
Use the snmp-host command to configure an SNMP host for the member devices
inside a cluster on the management device.
Use the undo snmp-host command to cancel the SNMP host configuration.
By default, no SNMP host is configured.
You need to configure the IP address of an SNMP host first for the cluster, in order that
the member devices in a cluster can send trap messages to the SNMP host through the
management device.
Execute these two commands on management devices only.
Example
# Configure an SNMP host for the cluster on the management device.
<aaa_0.Quidway> system-view
To Next Page
Loading...
Need help?
General