Huawei Quidway S3900 Series - SSH Client Configuration Commands; Display Ssh2 Source-Ip; Display Ssh Server-Info

Command Manual –SSH Terminal Service
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 SSH Terminal Service
Configuration Commands
Huawei Technologies Proprietary
1-20
Description
Use the ssh-server source-ip command to specify source IP address for SSH Server.
When the specified ip-address is not the IP address of the device, the command
prompts configuration fails.
Use the undo ssh-server source-ip command to cancel the specified IP address.
Then the address of the device determined by the system is for the user to access to
the switch.
Example
# Specify source IP address 192.168.0.1 for SSH Server.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ssh-server source-ip 192.168.0.1
1.2 SSH Client Configuration Commands
1.2.1 display ssh2 source-ip
Syntax
display ssh2 source-ip
View
Any view
Parameter
None
Description
Use the display ssh2 source-ip command to display the current source IP address set
for the SSH2 Client. If you specify a source interface for the SSH2 Client, the command
displays the IP address of the interface. If not, the command displays 0.0.0.0.
Example
# Display the current source IP address specified for the SSH2 Client.
<Quidway> display ssh2 source-ip
The source IP you specified is 192.168.0.1
1.2.2 display ssh server-info
Syntax
display ssh server-info