Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 6 PIM Configuration Commands
Huawei Technologies Proprietary
6-16
[Quidway] multicast routing-enable
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] pim timer hello 40
6.1.17 register-policy
Syntax
register-policy acl-number
undo register-policy
View
PIM view
Parameter
acl-number: Number of IP advanced ACL, defining the rule of filtering the source and
group addresses. The value ranges from 3000 to 3999.
Description
Use the register-policy command to configure a RP to filter the register packets sent
by the DR in the PIM-SM network and to accept the specified packets only.
Use the undo register-policy command to remove the configured packet filtering.
Example
# If the local device is the RP in the network, using the following command can only
accept multicast message register of the source sending multicast address in the range
of 225.1.0.0/16 on network segment 10.10.0.0/16.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] acl number 3010
[Quidway-acl-adv-3010] rule permit ip source 10.10.0.0 0.0.255.255
destination 225.1.0.0 0.0.255.255
[Quidway-acl-adv-3010] quit
[Quidway] multicast routing-enable
[Quidway] pim
[Quidway-pim] register-policy 3010
6.1.18 reset pim neighbor
Syntax
reset pim neighbor { all | { neighbor-address | interface interface-type
interface-number } * }
To Next Page
Loading...
Need help?
General