Huawei Quidway S3900 Series Command Manual

Command Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 PoE Configuration Commands
1.1 PoE Configuration Commands
1.1.1 display poe interface
Syntax
display poe interface [ interface-type interface-number ]
View
Any view
Parameter
interface-type interface-number: Port on the switch. Refer to Command Manual – Basic
Port Configuration for details.
Description
Use the display poe interface command to view the PoE status of a specific port of the
switch. If the interface-type interface-number argument is not specified, the command
displays the PoE status of all ports of the switch.
Example
# Display the PoE status of Ethernet 1/0/10.
<Quidway> display poe interface Ethernet1/0/10
Port power enabled :enable
Port power ON/OFF :on
Port power status : Standard PD was detected
Port power mode :signal
Port PD class :0
port power priority :low
Port max power :15400 mW
Port current power :460 mW
Port peak power :552 mW
Port average power :547 mW
Port current :10 mA
Port voltage :51 V

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English