Command Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-2
Table 1-1 Description on the fields of the display poe interface command
Field Description
Port power enabled PoE is enabled on the port
Port power ON/OFF The power on the port is on/off
Port power status
PoE status on the port:
z user command set port to off: PoE to the port is
turned off by the user
z Standard PD was detected: A standard PD is
detected
z PD detection is in process: PDs are being
detected
Port power mode
PoE mode on the port:
z signal: PoE through the signal cable
z spare: PoE through the spare cable
Port PD class Class of power to the PD
Port power priority
PoE priority of the port:
z critical: The highest
z high: High
z low: Low
Port max power The maximum available power on the port
Port current power The current power on the port
Port average power The average power on the port
Port peak power The peak power on the port
Port current The current on the port
Port voltage The voltage on the port
# Display the PoE status of all ports.
<Quidway> display poe interface
PORT INDEX POWER ENABLE MODE PRIORITY STATUS
Ethernet1/0/1 off disable signal low user command set port to off
Ethernet1/0/2 off disable signal low user command set port to off
Ethernet1/0/3 off disable signal low user command set port to off
Ethernet1/0/4 off disable signal low user command set port to off
Ethernet1/0/5 off disable signal low user command set port to off
Ethernet1/0/6 off disable signal low user command set port to off
Ethernet1/0/7 off disable signal low user command set port to off
Ethernet1/0/8 off disable signal low user command set port to off
Ethernet1/0/9 off disable signal low user command set port to off
Ethernet1/0/10 off disable signal low user command set port to off
Ethernet1/0/11 off disable signal low user command set port to off
To Next Page
Loading...
