Huawei Quidway S3900 Series Command Manual

Command Manual - Management VLAN
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Management VLAN Configuration
Commands
Huawei Technologies Proprietary
1-14
Summary count: 2
**Destination: 10.1.1.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 10.1.1.2 Interface: 10.1.1.2(Vlan-interface1)
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 3:23:44 Cost: 0/0 Tag: 0
**Destination: 10.1.1.2 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 3:23:44 Cost: 0/0 Tag: 0
Refer to Table 1-5 for the description on the output fields.
1.1.10 display ip routing-table protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose ]
View
Any view
Parameter
protocol: This argument can be one of the following:
z direct: Displays the information about the direct routes.
z ospf: Displays the information about OSPF routes.
z ospf-ase: Displays the information about ASE routes.
z ospf-nssa: Displays the information about NSSA routes.
z rip: Displays the information about RIP routes.
z static: Displays the information about the static routes.
inactive: Displays the information about the inactive routes. If you do not specify this
keyword, the information about both active and inactive routes is displayed.
verbose: Displays the detailed route information. If you do not specify this keyword,
only the summary route information is displayed.
Description
Use the display ip routing-table protocol command to display the information about
specific routes.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English