Huawei Quidway S3900 Series - Protocol-Vlan

Command Manual – VLAN
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 VLAN Configuration Commands
Huawei Technologies Proprietary
1-13
[Quidway] interface Ethernet1/0/1
[Quidway-Ethernet1/0/1] port hybrid protocol-vlan vlan 3 0 to 4
1.3.4 protocol-vlan
Syntax
protocol-vlan [ procotol-index ] { at | ip | ipx { ethernetii | llc | raw | snap } | mode
{ ethernetii etype etype-id | llc { dsap dsap-id ssap ssap-id } | snap etype etype-id } }
undo protocol-vlan { protocol-index [ to protocol-end ] | all }
View
VLAN view
Parameter
at: Specifies the VLAN to be an AppleTalk-based VLAN.
ip: Specifies the VLAN to be an IP-based VLAN.
ipx: Specifies the VLAN to be an IPX-based VLAN. The ethernetii, llc, raw and snap
keywords specify the four IPX encapsulation types.
mode: Configures user-defined protocol templates.
ethernetii: Ethernet II encapsulation format.
etype-id: Protocol type of the packet, in the range of 600 to FFFF.
llc: LLC encapsulation format.
dsap-id: Destination service access point. This argument ranges from 0 to FF.
ssap-id: Source service access point. This argument ranges from 0 to FF.
snap: SNAP encapsulation format.
etype-id: Protocol type of the packet, in the range of 600 to FFFF.
protocol-index: Beginning protocol index ranging from 0 to 4. Note that this argument
must be less than or equal to the protocol-end argument. If you do not specify this
argument, the beginning protocol index will be determined by the system.
protocol-end: End protocol index ranging from 0 to 4. Note that this argument must be
larger than or equal to the protocol-index argument.
all: Specifies all the protocol indexes.