Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Port Basic Configuration
Commands
Huawei Technologies Proprietary
1-26
Parameter
vlan-id-list: VLAN range to which the hybrid port will be added. vlan-id-list = [ vlan-id1
[ to vlan-id2 ] ]&<1-10>, where, vlan-id is in the range of 1 to 4094 and can be discrete,
and &<1-10> means you can input up to ten VLAN IDs/ID ranges.
tagged: Keeps VLAN tags when the packets of the specified VLANs are forwarded on
this port.
untagged: Keeps no VLAN tags when the packets of the specified VLANs are
forwarded on this port.
Description
Use the port hybrid vlan command to add the hybrid port into specified VLANs.
Use the undo port hybrid vlan command to remove the hybrid port from specified
VLANs.
A hybrid port can belong to multiple VLANs. When you use the command several times,
all VLAN specified in the commands will be allowed to pass the port.
The VLAN specified by the vlan-id argument must be existing. Otherwise, this
command is invalid. Related command: port link-type.
Example
# Add the hybrid port Ethernet1/0/1 to VLAN 2, VLAN 4 and VLAN 50 through VLAN
100, with tags assigned to their packets.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] vlan 2
[Quidway-vlan2] quit
[Quidway] interface ethernet 1/0/1
[Quidway-Ethernet1/0/1] port link-type hybrid
[Quidway-Ethernet1/0/1] port hybrid vlan 2 4 50 to 100 tagged
Operation complete, except these VLAN(s):
Non-existent VLAN(s)
1.1.27 port link-type
Syntax
port link-type { access | hybrid | trunk | irf-fabric }
undo port link-type
View
Ethernet port view
To Next Page
Loading...
