Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-19
If the build command is executed on the management device, the cluster name will be
modified.
The member number of a management device is 0.
After the cluster is set up, the S3900 switch will collect the topology information of the
network at the set interval and add the detected candidate devices into the cluster
automatically. If it is unnecessary to add the candidate switches into the cluster
automatically, you can set the interval of topology collection to 0, that is, topology
collection is not performed periodically.
Example
# Configure the current switch to be a management device and specify the cluster
name to be aaa.
<Quidway> system-view
System View: return to User View with Ctrl+Z
[Quidway] cluster
[Quidway-cluster] build aaa
To Next Page
Loading...
Need help?
General