Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Port Basic Configuration
Commands
Huawei Technologies Proprietary
1-4
Copying Protocol based VLAN configuration...
Copying LACP configuration...
Copying QOS configuration...
Copying GARP configuration...
Copying STP configuration...
Copying speed/duplex configuration...
 Note:
z Any aggregation group port you input in the destination port list will be removed from
the list and the copy command will not take effect on the port. If you want an
aggregation group port to have the same configuration with the source port, you can
specify the aggregation group of the port as the destination (with the
destination-agg-id argument).
z Any voice-VLAN-enabled port you input in the destination port list will be removed
from the list.
1.1.4 description
Syntax
description text
undo description
View
Ethernet port view
Parameter
text: Port description, a string of 1 to 80 characters.
Description
Use the description command to set a port description string.
Use the undo description command to remove the port description string.
By default, no description is defined for a port.
Example
# Set description string "lanswitch-interface" for the Ethernet1/0/1 port.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] description lanswitch-interface
To Next Page
Loading...
Need help?
General