Huawei Quidway S3900 Series - Page 165

Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Port Basic Configuration
Commands
Huawei Technologies Proprietary
1-8
Output(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 1-2 Description on the fields of the display interface command
Field Description
Ethernet1/0/1 current state
Current Ethernet port status: up or
down
IP Sending Frames' Format Ethernet frame format
Hardware address Port hardware address
Media type Media type
Port hardware type Port hardware type
100Mbps-speed mode, full-duplex mode Current speed mode and duplex mode
Link speed type is force link, link duplex
type is force link
Link speed and duplex status ( force or
auto-negotiation)
Flow-control is enabled Status of flow-control on the port
The Maximum Frame Length
Maximum frame length allowed on the
port
Broadcast MAX-ratio
Broadcast suppression ratio on the
port
Unicast MAX-ratio
Unknown unicast suppression ratio on
the port
Multicast MAX-ratio Multicast suppression ratio on the port
Allow jumbo frame to pass
Whether Jumbo frame is allowed on
the port.
PVID Default VLAN ID of the port
Mdi type Network cable type
Port link-type Port link type
Tagged VLAN ID
Identify the VLANs whose packets will
be forwarded with tags on the port.
Untagged VLAN ID
Identify the VLANs whose packets will
be forwarded without tags on the port.
Last 300 seconds input: 0 packets/sec 0
bytes/sec
Last 300 seconds output: 0 packets/sec 0
bytes/sec
Rate and number of incoming and
outgoing packets in the last 300
seconds