Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Table of Contents
Huawei Technologies Proprietary
iii
3.1.37 ospf mib-binding.................................................................................................. 3-41
3.1.38 ospf mtu-enable ..................................................................................................3-42
3.1.39 ospf network-type................................................................................................ 3-43
3.1.40 ospf timer dead.................................................................................................... 3-44
3.1.41 ospf timer hello.................................................................................................... 3-45
3.1.42 ospf timer poll...................................................................................................... 3-45
3.1.43 ospf timer retransmit ...........................................................................................3-46
3.1.44 ospf trans-delay................................................................................................... 3-47
3.1.45 peer ..................................................................................................................... 3-48
3.1.46 preference ........................................................................................................... 3-48
3.1.47 reset ospf............................................................................................................. 3-49
3.1.48 router id ...............................................................................................................3-50
3.1.49 silent-interface..................................................................................................... 3-51
3.1.50 snmp-agent trap enable ospf ..............................................................................3-52
3.1.51 spf-schedule-interval........................................................................................... 3-53
3.1.52 stub...................................................................................................................... 3-54
3.1.53 vlink-peer............................................................................................................. 3-54
Chapter 4 IP Routing Policy Configuration Commands............................................................ 4-1
4.1 IP Routing Policy Configuration Commands .....................................................................4-1
4.1.1 apply cost ................................................................................................................ 4-1
4.1.2 apply tag.................................................................................................................. 4-2
4.1.3 display ip ip-prefix ................................................................................................... 4-2
4.1.4 display route-policy ................................................................................................. 4-3
4.1.5 if-match acl............................................................................................................. 4-4
4.1.6 if-match cost............................................................................................................ 4-5
4.1.7 if-match interface..................................................................................................... 4-6
4.1.8 if-match ip next-hop................................................................................................. 4-7
4.1.9 if-match tag.............................................................................................................. 4-8
4.1.10 ip ip-prefix.............................................................................................................. 4-8
4.1.11 route-policy.......................................................................................................... 4-10
Chapter 5 Route Capacity Configuration Commands ............................................................... 5-1
5.1 Route Capacity Configuration Commands ........................................................................ 5-1
5.1.1 display memory ....................................................................................................... 5-1
5.1.2 display memory limit................................................................................................5-2
5.1.3 memory auto-establish disable ............................................................................... 5-3
5.1.4 memory auto-establish enable................................................................................ 5-4
5.1.5 memory safety | limit .............................................................................................. 5-5
To Next Page
Loading...
