Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-20
View
Any view
Parameter
process-id: OSPF Process ID. If you do not specify a process ID, this command applies
to all current OSPF processes.
interface-type interface-number: Interface type and interface number.
Description
Use the display ospf interface command to display the OSPF interface information.
Example
# Display the OSPF interface information of Vlan-interface1.
<Quidway> display ospf interface vlan-interface 1
OSPF Process 1 with Router ID 1.1.1.1
Interfaces
Interface: 10.110.10.2 (Vlan-interface1)
Cost: 1 State: BackupDR Type: Broadcast
Priority: 1
Designated Router: 10.110.10.1
Backup Designated Router: 10.110.10.2
Timers: Hello 10, Dead 40, Poll 10, Retransmit 5, Transmit Delay 1
Table 3-6 Description on the fields of the display ospf interface command
Field Description
Cost Cost of the interface
State State of the interface state machine
Type Network type of OSPF
Priority Priority of DR for interface election
Designated Router DR on the network in which the interface resides
Backup Designated Router BDR on the network in which the interface resides
OSPF timers, defined as follows:
Hello Interval of hello packet
Dead Interval of dead neighbors
Poll Interval of poll
Timers
Retransmit Interval of retransmitting LSA
Transmit Delay Delay time of transmitting LSA
To Next Page
Loading...
