Command Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 Commands for User Control
Huawei Technologies Proprietary
2-4
undo snmp-agent group { v1 | v2c } group-name
snmp-agent group v3 group-name [ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ] [ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group v3 group-name [ authentication | privacy ]
View
System view
Parameter
v1: Specifies to adopt v1 security scheme.
v2c: Specifies to adopt v2c security scheme.
v3: Specifies to adopt v3 security scheme.
group-name: Group name. This argument can be of 1 to 32 characters.
authentication: Specifies to authenticate SNMP data without encrypting the data.
privacy: Authenticates and encrypts packets.
read-view: Sets a read-only view.
read-view: Name of the view to be set to read-only. This argument can be of 1 to 32
characters.
write-view: Sets a readable & writable view.
write-view: Name of the view to be set to readable & writable. This argument can be of
1 to 32 characters.
notify-view: Sets a notifying view.
notify-view: Name of the view to be set to a notifying view. This argument can be of 1 to
32 characters.
acl acl-number: Specifies an ACL. The acl-number argument ranges from 2,000 to
2,999.
Description
Use the snmp-agent group command to create a SNMP group. You can also
optionally use this command to apply an ACL to filter network management users.
Use the undo snmp-agent group command to remove a specified SNMP group.
By default, the snmp-agent group v3 group-name command is provided without the
authentication and privacy keyword. That is, the switch does not authenticate or
encrypt the specified group.
Example
# Create a SNMP group named “h123” and apply ACL 2001 to filter network
management users (assuming that ACL 2001 already exists).
To Next Page
Loading...
