Huawei Quidway S3900 Series Command Manual

Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 7 MSDP Configuration Commands
Huawei Technologies Proprietary
7-4
source-address: Source address of the (S, G) entry. If you do not specify a source
address, the system displays all source information of the specified group. If you
specify neither a group address nor a source address, the system displays all SA
caches.
autonomous-system-number: Number of the AS where the (S,G) entry comes from.
The value ranges from 1 to 65535.
Description
Use the display msdp sa-cache command to display (S, G) state learned from an
MSDP peer.
You must configure the cache-sa-enable command before the system can display the
cache state information.
Example
# Display SA messages learned from the MSDP peer.
<Quidway> display msdp sa-cache
MSDP Total Source-Active Cache - 5 entries
(Source, Group) Origin RP Pro AS Uptime Expires
(10.10.1.2, 225.1.1.1) 10.10.10.10 ? ? 00:00:10 00:05:50
(10.10.1.3, 225.1.1.1) 10.10.10.10 ? ? 00:00:11 00:05:49
(10.10.1.2, 225.1.1.2) 10.10.10.10 ? ? 00:00:11 00:05:49
(10.10.2.1, 225.1.1.2) 10.10.10.10 ? ? 00:00:11 00:05:49
(10.10.1.2, 225.1.2.2) 10.10.10.10 ? ? 00:00:11 00:05:49
MSDP matched 5 entries
Table 7-2 Description on the fields of the display msdp sa-cache command
Field Description
(Source, Group) (S, G) entry
Origin RP Source RP address
Pro Inter-domain unicast routing protocol
AS AS number
Uptime Up time
Expires Expiry of a (S, G) entry

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English