Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-27
verbose: Displays the detailed information about all the candidate devices.
Description
Use the display cluster candidates command to display the information about the
candidate devices of a cluster. The command is applicable to the management devices
only.
After the cluster is set up, the S3900 switch will collect the topology information of the
network at the set interval and add the detected candidate devices into the cluster
automatically. As a result, if the interval of topology collection is too short (which is 1
minute by default), the switch exists as the candidate device of the cluster for a short
time. If it is unnecessary to add the candidate switches into the cluster automatically,
you can set the interval of topology collection to 0, that is, topology collection is not
performed periodically.
Execute this command on management devices only.
Example
# Display the information about all the candidate devices.
<aaa_0.Quidway-cluster> display cluster candidates
MAC HOP IP PLATFORM
3900-0000-3334 2 16.1.1.11/24 S3900
00e0-fc00-3190 1 16.1.1.1/24 S3900
Table 1-6 Description on the fields of the display cluster candidates
command (A)
Field Description
MAC
MAC address of a candidate
device
Hop
Hops from a candidate device to
the management device
IP IP address of a candidate device
Platform Platform of a candidate device
# Display the information about a specified candidate device.
<aaa_0.Quidway-cluster> display cluster candidates mac-address
00e0-fc00-3190
Hostname : 3900-3
MAC : 00e0-fc00-3190
Hop : 1
To Next Page
Loading...
