Huawei Quidway S6500 Series - Page 107

Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
Chapter 1 IP Address Configuration
Commands
Huawei Technologies Proprietary
1-2
Description
Using display ip interface command, you can view the information of an IP interface.
By default, the information about all the IP interfaces will be displayed if undo interface
is specified. This command outputs all the information related to IP on the interface,
which is useful for troubleshooting.
Example
# Display the information related to interface VLAN-Interface 1.
<Quidway> display ip interface vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
The Maximum Transmit Unit : 1500 bytes
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
TTL invalid packet number: 0
ICMP packet input number: 0
Echo reply: 0
Unreachable: 0
Source quench: 0
Routing redirect: 0
Echo request: 0
Router advert: 0
Router solicit: 0
Time exceed: 0
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
Unknown type: 0
# Display basic configuration information.
<Quidway S6506R> display ip interface brief
Interface IP Address Physical Protocol
M-Ethernet0/0/0 unassigned down down
Vlan-interface1 1.1.1.1 down down