Command Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 4 IGMP Configuration Commands
Huawei Technologies Proprietary
4-8
Description
Using igmp host-join port command, you can enable an port in the VLAN interface of
an ethernet switch to join a multicast group. Using undo igmp host-join port
command, you can disable the configuration.
By default, an interface does not join any multicast group.
For the related command, see igmp host-join vlan, igmp host-join and igmp
group-policy.
Example
# Add port Ethernet 0/1 in VLAN-interface10 to the multicast group at 225.0.0.1.
[Quidway-Vlan-interface10] igmp host-join 225.0.0.1 port Ethernet 0/1
4.1.10 igmp host-join vlan
Syntax
igmp host-join group-address vlan vlan_id
undo igmp host-join group-address vlan vlan_id
View
Ethernet port view
Parameter
group-address: Multicast address of the multicast group that an interface will join.
vlan_id: Specifies the ID for the VLAN to which the port belongs.
Description
Using igmp host-join vlan command, you can enable an port in the VLAN interface of
an ethernet switch to join a multicast group. Using undo igmp host-join vlan
command, you can disable the configuration.
By default, a port does not join any multicast group.
This command has the same function with the igmp host-join port command. Note
that the configured port must belong to the specified VLAN, and the IGMP protocol
must be enabled on this VLAN interface; otherwise, the configuration does not function.
For the related command, see igmp host-join port, igmp host-join, igmp
group-policy.
Example
# Add port Ethernet 0/1 in VLAN-interface10 to the multicast group at 225.0.0.1.
[Quidway-Vlan-interface10] igmp enable
To Next Page
Loading...
