Huawei Quidway S6500 Series - Poe Max-Power

Command Manual - PoE
Quidway S6500 Series Ethernet Switches Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-9
Parameter
slot-num: Slot number.
Description
Using the poe legacy enable slot command, you can enable PoE-compatibility
detection on the board to check if the connected PDs are IEEE802.3af-compatible.
Using the undo poe legacy slot command, you can disable the PoE-compatibility
detection on the board.
By default, PoE-compatibility detection is not enabled on the board.
The switch can detect the PDs incompatible with IEEE802.3af and deliver current to
them over the Ethernet ports.
Caution:
PoE-compatibility detection process is very slow and has impact on the system
performance, so you are recommended not to enable the PoE-compatibility detection
on a board if all PDs connected are IEEE802.3af-compatible.
Example
# Enable PoE-compatibility detection on the PoE board in slot 2.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] poe enable slot 2
[Quidway] poe legacy enable slot 2
1.1.8 poe max-power
Syntax
poe max-power max-power
undo poe max-power
View
Ethernet port view
Parameter
max-power: Maximum power distributed to the port, ranging from 1000 to 15400 mW.