Huawei Quidway S6500 Series - Slave Switchover; Slave Update Configuration

Command Manual - Reliability
Quidway S6500 Series Ethernet Switches Chapter 2 HA Configuration Commands
Huawei Technologies Proprietary
2-3
Example
# Restart the slave board.
<Quidway> slave restart
The slave will reset! Continue?[Y/N]:y
2.1.4 slave switchover
Syntax
slave switchover
View
User view
Parameter
None
Description
Use the slave switchover command to perform master/slave switchover manually.
When the slave board operates normally and the master board is in the real-time
backup state, if you want the slave board to be the master board to ensure the
operation of the system, you can use this command to implement master/slave
switchover. After that, the slave board becomes the new master board and controls the
system, and the original master board restarts automatically.
Example
# Perform master/slave switchover manually.
<Quidway> slave switchover
Caution!!! Confirm switch slave to master[Y/N]?y
Starting.....
RAM Line....OK
2.1.5 slave update configuration
Syntax
slave update configuration