Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 2 MAC Address Table Management Commands
Huawei Technologies Proprietary
2-4
Description
Using mac-address command, you can add/modify the MAC address table entry.
Using undo mac-address command, you can cancel MAC address table entry
If the input address has been existed in the address table, the original entry will be
modified. That is, replace the interface pointed by this address with the new interface
and the entry attribute with the new attribute (dynamic entry and static entry).
All the (MAC unicast) addresses on a certain interface can be deleted. User can choose
to delete any of the following addresses: address learned by system automatically,
dynamic address configured by user, static address configured by user.
Because the address table is shared in the VLAN domain, you need specify the VLAN
of the multicast address and the port of the unicast address, when adding entries to the
address table.
For the related commands, see display mac-address.
Example
# Configure the port number corresponding to the MAC address 00e0-fc01-0101 as
Ethernet2/0/1 in the address table, and sets this entry as static entry.
[Quidway] mac-address static 00e0-fc01-0101 interface ethernet 2/0/1 vlan 2
2.1.5 mac-address max-mac-count
Syntax
mac-address max-mac-count count
undo mac-address max-mac-count
View
Ethernet port view
Parameter
count: Specify the amount limit to the MAC addresses to be learned, ranging from 0 to
16384. 0 indicates that no address can be learned via the port. By default, it is 16384.
Description
Using mac-address max-mac-count command, you can set a limit to the MAC
addresses to be learned by the Ethernet port. Using undo mac-address
max-mac-count command, you can restore the default max count of the MAC
addresses to be learned by the Ethernet port.
By default, the max count of MAC addresses learned via the Ethernet port is 16384.
The port will stop learning MAC address when the amount reaches the limit specified by
the count parameter.
To Next Page
Loading...
Need help?
General
