Huawei Quidway S6500 Series Command Manual

Command Manual - Security
Quidway S6500 Series Ethernet Switches Chapter 2 AAA Configuration Commands
Huawei Technologies Proprietary
2-42
2.2.25 timer
Syntax
timer seconds
undo timer
View
RADIUS scheme view
Parameter
seconds: RADIUS server response timeout timer, ranging from 1 to 10 and measured in
seconds. By default, the value is 3.
Description
Using timer command, you can configure RADIUS server response timer. Using undo
timer command, you can restore the default value of the timer.
After RADIUS (authentication/authorization or accounting) request packet has been
transmitted for a period of time, if NAS has not received the response from RADIUS
server, it has to retransmit the message to guarantee RADIUS service for the user. The
period taken is called RADIUS server response timeout time, which is controlled by the
RADIUS server response timeout timer in the switch system. This command is used to
set this timer.
Setting a suitable timer according to the network situation will enhance the system
performance.
For the related commands, see radius scheme, retry.
Example
# Set the response timeout timer of RADIUS scheme, huawei, to 5 seconds.
[Quidway-radius-huawei] timer 5
2.2.26 timer quiet
Syntax
timer quiet minutes
undo timer quiet
View
RADIUS scheme view

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English