Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IPX Configuration Commands
Huawei Technologies Proprietary
7-11
Parameter
seconds: RIP update interval in seconds. It is in the range 10 to 60000 and defaults to
60.
Description
Using the ipx rip timer update command, you can configure a RIP update interval.
Using the undo ipx rip timer update command, you can restore the default.
For the related command, see ipx rip multiplier.
Example
# Set the RIP update interval to 30 seconds.
[Quidway] ipx rip timer update 30
7.1.13 ipx route load-balance-path
Syntax
ipx route load-balance-path paths
undo ipx route load-balance-path
View
System view
Parameter
paths: The maximum number of equivalent routes to the same destination. It is in the
range 1 to 64 and defaults to 1.
Description
Using the ipx route load-balance-path command, you can configure the number of
equivalent routes to the same destination. Using the undo ipx route
load-balance-path command, you can restore the default.
The number of equivalent routes configured using this command is the maximum
number of active equivalent routes to the same destination in the current system. If
the new number is less than the number of the current active routes, the system
deactivates those excessive.
Example
# Set the number of equivalent routes to the same destination to 30.
[Quidway] ipx route load-balance-path 30