Huawei Quidway S6500 Series Command Manual

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-23
channel-name: Specify the channel name. The name can be channel6, channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer.
Description
Using info-center snmp channel command, you can configure new channel for
transmitting the SNMP information. Using undo info-center snmp channel command,
you can restore the channel for transmitting the SNMP information to default value.
For the related commands, see display snmp.
Example
# Configure channel 6 as the SNMP information channel.
[Quidway] info-center snmp channel 6
4.5.14 info-center source
Syntax
info-center source { modu-name | default } channel { channel-number |
channel-name } [ { log | trap | debug } * { level severity | state state ] } *
undo info-center source { modu-name | default } channel { channel-number |
channel-name }
View
System view
Parameter
modu-name: Module name.
default: All the modules.
log: Log information.
trap: Trap information.
debugging: Debugging information.
level: Level.
severity: Information level, do not output information below this level.
Information at different levels is as follows:
emergencies: Level 1 information, which cannot be used by the system.
alerts: Level 2 information, to be reacted immediately.
critical: Level 3 information, critical information.
errors: Level 4 information, error information.
warnings: level 5 information, warning information.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English