Huawei Quidway S6500 Series - Display Pim Routing-Table

Command Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-10
Field Description
Uptime Time passed since the multicast group has been discovered
Expires Specifies when the member will be removed from the group
5.1.11 display pim routing-table
Syntax
display pim routing-table [ { { *g [ group-address [ mask { mask-length | mask } ] ] |
**rp [ rp-address [ mask { mask-length | mask } ] ] } | { group-address [ mask
{ mask-length | mask } ] | source-address [ mask { mask-length | mask } ] } * } |
incoming-interface { interface-type interface-number | null } | { dense-mode |
sparse-mode } ] *
View
Any view
Parameter
**rp: (*, *, RP) route entry.
*g: (*, G) route entry.
group-address: Address of the multicast group.
source-address: IP address of the multicast source.
incoming-interface interface-type interface-number: Route entry with the specified
incoming interface.
null: Specifies the incoming interface type as Null.
dense-mode: Specifies the multicast routing protocol as PIM-DM.
sparse-mode: Specifies the multicast routing protocol as PIM-SM.
Description
Using display pim routing-table command, you can view the contents of the PIM
multicast routing table.
For the related command, see display multicast routing-table.
Example
# View the contents of the PIM multicast routing table on the router.
<Quidway> display pim routing-table
PIM-SM Routing Table
Total 0 (*,*,RP)entry, 0 (*,G)entry, 2 (S,G)entries