Huawei Quidway S6500 Series Command Manual

Command Manual - PoE
Quidway S6500 Series Ethernet Switches Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-11
Example
# Set the maximum power on a board.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] poe max-power 400 slot 3
# Restore the default maximum power on the board.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] undo poe max-power slot 3
1.1.10 poe mode
Syntax
poe mode { signal | spare }
undo poe mode
View
Ethernet port view
Parameter
signal: The port will supply power through signal lines.
spare: The port will supply power through spare lines
Description
Using the poe mode command, you can configure the power feeding mode on current
port.
Using the undo poe mode command, you can restore the default mode on current
port.
By default, the port adopts signal lines to supply power
Note that S6506 switch currently does not support the spare mode. If a PD only
supports the spare mode, a conversion will be needed.
Example
# Configure the power feeding mode on current port to auto.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface ethernet3/0/1
[Quidway-Ethernet3/0/1] poe mode signal

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English